Vertex G4 (5 cr)
Code: N-TT0531-3006
General information
- Enrolment period
- 09.05.2018 - 25.09.2018
- Registration for the implementation has ended.
- Timing
- 24.09.2018 - 31.12.2018
- Implementation has ended.
- Credits
- 5 cr
- Virtual portion
- 5 cr
- RDI portion
- 5 cr
- Mode of delivery
- Online learning
- Unit
- Mechanical Engineering
- Campus
- TAMK Main Campus
- Teaching languages
- Finnish
- Seats
- 0 - 50
- Degree programmes
- Degree Programme in Mechanical Engineering
Objectives (course unit)
The student masters the CAD based product design and development process with Vertex CAD software.
Content (course unit)
In the course, the 3D-modeling (parts, assemblies, drawings) is dealed with Vertex CAD software.
Location and time
The course can be studied independently without time restrictions. It is possible to load Vertex G4 to one's own device. All parts must be downloaded to the PDM-system which is located in the local network of TAMK.
Assessment scale
0-5
Teaching methods
The course will be realized as a virtual course. Educational videos from every operation needed are available for the students.
Learning materials
Extra learning materials will not be needed.
Completion alternatives
No alternative ways to pass the course.
Further information
Watch the introduction video of the course from the link below.
(added later)
1) Sign up for the course in Pakki
2) Add yourself to the Tabula for the course Vertex G4 2018 (course key; G4)
3) Check the instructions from the file "Material"
4) Watch the video and follow the instructions
Assessment criteria - satisfactory (1-2) (Not in use, Look at the Assessment criteria above)
The student has returned some material with his/her own pictures, but some parts are missing and the returned pictures are incomplete.
Assessment criteria - good (3-4) (Not in use, Look at the Assessment criteria above)
The student has returned the material with his/her own moderate pictures, but with some lacks, or there are problems with basic design (collision between parts etc.)
Assessment criteria - excellent (5) (Not in use, Look at the Assessment criteria above)
The student has returned the material with his/her own pictures completely or almost completely and has tried to design an extra assignment so that it could be produced in reality.